Hospital high-touch surface disinfection
| Maximum Total Input Power: | 3600W |
| Output Energy: | 300J/Pulse |
| Operating Temperature: | -5~+40℃ |
| Relative Humidity: | 20%~90% |
| Xenon Lamp Life: | 20,000,000 Pulse |
| Input Voltage Range: | 110VAC/220VAC |
| Operating Frequency: | 1HZ/3HZ |
| Storage Temperature: | -40~+60℃ |
| Heat Dissipation Mode: | Natural Air Cooling |
| Port: | Shenzhen/Guangzhou |
Applied with PUVC technology, Pulster emit very high energy in a very short period of time ,so as to inactivate various of pathogens. The wide range of spectrum with the peak energy in UVC wavelength of 200nm to 320nm effectively disable the chain of microorganisms DNA.
The areas of ICU, operating unit, patients ward or other surfaces are always more easily contaminated by pathogens including C.Diff, MRSA, VRE, CRE, and Acinetobacter . Hospital high touch surface includesbed side rail, overbed table, television remote, bathroom grab bar, and toilet seat in the patient’s bathroom...
Traditional UVC lamp takes around 1.5 to 2 hours to complete the disinfection process, while Pulster only takes around 10 minutes.
Pulster offers benefits:
10 minutes disinfectin
Around 10 minutes. More rapid than chemical disinfectant and traditional UVC lamp. Enable new patients’ quick entrance into hospital room.
99.99% Effectiveness
Clear 99.99% of virus. result in decrease of hospital associated infeciton, lincluding the superbut,C.Diff, MRSA, VRE, CRE, and Acinetobacter.
Safe
Cause no any chemical side effects. Remote control, closed glass can block all the irritation.
Environmental
No mercury, Green gas, no burden to environment
Cost-saving
No chemical consumables, long lamp lifetime. Greatly reduce the hospital cost which HAI induces and hospital human resource, and business cost.
